Substrate preparation
Remove loose or weak concrete, oil, dust and contamination. Mechanically roughen unsuitable smooth areas.
HomeTechnical support & application guidance
Technical support & application guidance
Give contractors and project buyers the information required to evaluate, test and apply the material responsibly.
Moisture condition
Pre-wet the substrate thoroughly and remove standing water before placement.
Mixing control
Use clean water at 16%–18% of product weight and mechanically mix for approximately 3 minutes.
Placement window
Complete final placement within approximately 10 minutes after mixing under standard conditions.
Temperature limit
Apply only when air and substrate temperatures are between 5°C and 35°C.
Site protection
Protect the repair from premature traffic, rain, strong wind, extreme heat and freezing.
Technical limitations
- •Typical laboratory data are not third-party certified guarantees.
- •No public heavy-vehicle reopening claim is made.
- •Asphalt use is excluded from the standard public recommendation.
- •No unsupported freeze-thaw, abrasion or shrinkage claims are published.